Project Giant Intake Manifold

[nickspeed]

Manifold is off a 06+ FX45 and a 06+ M45.

[O-Fivecc]

Can't wait for this to get finished. Have you seen the TB that is supposedly coming out (over on MT)....I hope their TB and this manifold will bolt-up....Be sure to let me know if you get some gains out of this

[nickspeed]

I read the whole post on ct. When the TB comes out, I will see if jwt can get one and see if it fits this, that would be a sick combo for shure!

[O-Fivecc]

Yes it would. It would be cool to run low 13's without cams LOL, and mid 12's with bolt-ons and Nitrous.....Might even be able to get mid 12's from an NA cammed/stalled motor with this. low 12's seems possible since the cams are all about getting more air, and with this mod, its hard to say just how benificial it may be

[Shaggy]

Anymore pics of this project? How far are you into it?

[nickspeed]

This is the only pic so far,more to flow as they come.

[nickspeed]

Yes it would. It would be cool to run low 13's without cams LOL, and mid 12's with bolt-ons and Nitrous.....Might even be able to get mid 12's from an NA cammed/stalled motor with this. low 12's seems possible since the cams are all about getting more air, and with this mod, its hard to say just how benificial it may be

Plus it you want to just set up you truck for draggin, you can get the N8 cams. You would have to set you idle high cause they will not idle low, to much over lap. But they would be rocket on the top end. ANd they would suck for daily driving, that is why the S2 are used.

[von]

Any more updates? I want it now.

[nickspeed]

Lol, working on the TB mount and fuel rails. The FX manifold is smaller across there the titan ones.

[von]

Kool. So he will sell the fuel rails with the kit? Or is it a one of kt??