Intake question?

[nickspeed]

Jwt says run the plastic tubes if at all possible. Plastic tubing will cool off faster then hot metal tubing anyday. But the metal tube still show inprovement over stock so they do work. I would get the banks if it wasnt so much coin.

[O-Fivecc]

Though he's def right. Probably not a huge difference with the metal tube only running 1/4 mile with 4 inches of cool outside air being shoveled into the box. Also, I had DEI heatwrap on my AEM, that stuff worked great to keep the intake tune from getting hot....Now sitting in traffic with a metal tube will def raise the IAT

[nickspeed]

Yea it will be fine for the stip as long as you let it cool down between runs. And the heat rap is a very good idea.

[Warp09]

My Injen black satin tube runs way cooler than my Volant tube. Any idea?

[nickspeed]

My Injen black satin tube runs way cooler than my Volant tube. Any idea?

Not shure on that one, Injen has two model of intakes right? A steet verison and a off road verison?

[Layer1]

I didnt say anything before but I was running Cipher on Injen and Banks, Banks came out 10-20° cooler. Nearly same conditions outside.

[kha4079]

<<<<<<<- - - - - - - - - - - stock air box with a fram high flow filter and a 4 inch ram air with the air silencer removed

[nickspeed]

I didnt say anything before but I was running Cipher on Injen and Banks, Banks came out 10-20° cooler. Nearly same conditions outside.

That sounds about right. Did they both gain the same amount of ° when setting in traffic? It that case the plastic should cool off quicker when you get back up to speed compared to the metal set up.

[08BLIZZARD]

a garbage k&n for now.. soon to be swapped

[bills1974]

AEM Brute Force